www.customduo.co.uk

CustomDUO

www.customduo.co.uk

Pitlamp Omni v5

gallery/custompitlamp page topper

Based on our Duo Omni module, the PL Omni is the most sophisticated and effective mining lamp LED conversion available, with user programmable settings up to 620 lumens. 

 

Now available with new Cree XP-G3 s5 LEDs providing minimum of 172 lumen/watt @85degC and 187 lumen/watt @25degC. Light temperature 5000K (neutral white).

 

 

 

 

£70

 

Specification

 

 

  • Twin high power s5 XP-G2 LEDs (172 lumen @ 350mA @ 85 degC) 5000k neutral tint
  • Smooth spot optic for distant focus & flood LED (with efficient optic for forward bias), for maximum usability
  • LEDs operated separately or blended together
  • Programmable; range of user defined power combinations to best suits your individual requirements
  • 620 lumen maximum output; combined 'spot' 310 lumen and 'flood' 310 lumen
  • Separate low power comfort LED (warm white) on independent circuit 
  • Super robust circuit architecture. Custom heat sink, and discreet thermal management
  • Simple fitting, 3 screw terminal connections in Oldham / CEAG headset
  • No power drain when lamp is switched 'off' with batteries connected
  • Progressive dimming at end of battery charge; will not just shut off when batteries are flat and cannot sustain full output

 

To switch between the four factory default power settings (see following table), in a looping sequence, use the 'forward' switch on the mining lamp. Switch on-off-on-off to sequence between settings 1-2-3-4 ... 1-2 etc. 

'Backward' switch (using secondary switch position) to operate seperate low power LED, moon mode (10mA flood).

 

 

Operation Overview

 

For further information about operaton, and how to program and configure settings, see the PL Omni Operation page.

 

Suitable for lamps that run from 3.6 volts to 6.0 volts (maximum), typically a 3 or 4 cell battery configuration. This includes Speleo Technics Headlites and FX3s, and lead acid mining lamps. Not suitable for 2.4v 2 series cell lamps such as FX2. For information on 5 cell 6v+ lamps such as FX5, contact us.

 

Pitlamp module fitting

 

Factory Setting

Spot LED

Flood LED

Output

(estimated)

Duration

(est.  using 2500mAh
eneloops)

1 (fixed)

-

150mA

73 lumens

16 hours

2 (programmable)

-

350mA

172 lumens

7 hours

3 (programmable)

150mA

350mA

245 lumens

5 hours

4 (programmable)

700mA

-

310 lumens

3.5 hours

Secondary switch

-

10mA

5 lumens

includes battery
level indicator