Q-350 (v2) Module
Retrofit LED module for UK (Underwater Kinetics) Mini Q40 dive lights, often used by cavers as back-up lights. Fits original Xenon Mini q40. Does not fit eLed version. See notes below.
Now available with new Cree XP-G3 s5 LED providing minimum of 172 lumen/watt @85degC and 187 lumen/watt @25degC. Light temperature 5000K (neutral white).
Q350 (v2) Fitting
The Q350 (v2) requires the brass collar from the old xenon module that is being removed and replaced (see photo). The brass collar can be seen on the original xenon module (the one at back of photo). The second module back is also an original xenon module, but with the collar removed, and subsequently fitted to Customduo Q350 module (the one at front of photo). The brass collar is easily extracted from old xenon module and easily fitted to Q350 (v2) module.
When fitting, test module is working, by pressing down with thumb to turn on. If not working then investigate polarity and connectivity. If testing OK, then refit Mini Q40 bezel by screwing down clockwise until the module lights up. When bezel is unscrewed, spring pressure in battery arrangement should be sufficient to turn module off. We advise that you only screw down bezel so far that module comes on. Screwing down further could potentially cause damage to the module and to the negative connection in Mini Q40. Similarly, only unscrew bezel far enough for light to go off. Operate light at the 'sweet spot' of bezel rotation.
The original mini Q40, 'the best selling dive torch on the planet', features an expensive to replace xenon bulb module, providing 38 lumens at a hefty 2.1 watts. This is the model (shown above) and can be upgraded with the Flippin Tec Q350 Module.
The latest version, the mini eLED plus runs at a quoted 2 watts (considerably more than a Fippin Tec Q-350 module), but produces just 67 lumens. Note, the Flippin Tec module will not fit the eLED version, as it has an extended front end, when compared to the original, upgradeable UK Mini Q40 xenon.